GE GSC720 Use And Care Manual page 4

Before Operating Your Dishwasher the First Time...
Attach the Faucet Adapter. The special faucet adapter
supplied with your dishwasher must be assembled to the
sink faucet before you can use your dishwasher.
The faucet adapter is designed to fit standard spouts
having internal or external threads. You will find the
adapter and two washers in the "Faucet Adapter"
packet in your dishwasher.
To install faucet adapter, first remove the old aerator
or trim ring on your faucet spout.
If faucet has external threads:
Insert the thinner of the two
washers into the faucet adapter
and attach it to the faucet spout.
Tighten with pliers.
How to Connect the Unicouple
1. Pull Unicouple and its hoses completely out from
storage compartment located at rear of dishwasher
and attach it to the faucet adapter.
2. Attach the Unicouple
connector to the
faucet adapter by
depressing the
collar at the top
of the connector.
When Unicouple
is all the way up
onto the adapter,
release the collar. It will then
snap into position to lock the Unicouple in place.
How to Disconnect the Unicouple from Faucet Adapter
1. Turn off the hot water.
2. Release the water pressure by depressing
the pressure release button. This relieves water
pressure and protects you, and the room, from
severe splashing.
How to Disconnect Your Dishwasher
1. Remove the power cord plug from the wall
receptacle.
2. Disconnect Unicouple from faucet adapter.
4
HOW TO USE THE UNICOUPLE
If faucet has internal threads:
Insert both of the washers into
the faucet adapter and attach it
to the faucet spout.
Tighten with pliers.
If the faucet adapter threads
do not match your faucet spout,
your local hardware or plumbing
supply store normally has additional
fittings to adapt your faucet spout to
the special faucet adapter.
NOTE: A sink spray attachment hose can burst if it
is installed on the same sink with your dishwasher.
We suggest that you disconnect the sink spray
attachment if your sink has one and plug the hole.
The Unicouple's small hose carries water from
the faucet to the dishwasher. Its large hose carries
drain water to the sink. Be sure Unicouple is
pointing toward the sink bowl drain opening and
the sink drain is open for water that will drain from
your dishwasher. If your dishwasher drains into a
disposer, operate the disposer until it is completely
empty before starting the dishwasher.
3. Turn hot water fully on before starting the dishwasher.
3. Release Unicouple from faucet by depressing
the collar at the top of the Unicouple connector.
NOTE: When motor stops at the end of the final
rinse, the Unicouple can be disconnected and returned
to storage.