GE GSD4310 Use And Care Manual page 5

2
*Using the Cycles on the Dial
SHORT WASH
1. Select the NORMAL WASH cycle and any options.
2. Be sure the door is unlatched.
3. Slowly turn the Dial to SHORT WASH.
4. Latch the door to start the cycle.
RINSE & HOLD
1. Make sure NORMAL WASH cycle and ENERGY
SAVER are selected.
2. Be sure the door is unlatched.
3. Slowly turn the Dial to RINSE & HOLD.
4. Latch the door to start the cycle.
Energy Options Descriptions
TEMP BOOST
Provides extra heat for best
performance. It is used best with
heavily-soiled dishes.
Cycle Sequence Chart
Water Use
Gallons
Wash Cycles
(approx.)
POTSCRUBBER 11.1
NORMAL WASH 9.5
LIGHT WASH 8.0
CHINA CRYSTAL 6.7
SHORT WASH 6.9
RINSE & HOLD
0.3
HEATED DRY
Turns the drying heater on for fast
drying. This cycle will extend the
time to your wash cycle.
Wash Cycle
Time
Minutes
(approx.) Cycle Sequence
61
Main
Rinse Rinse Rinse Wash Rinse Rinse Rinse
61
Rinse Rinse Rinse
61
Rinse Rinse
61
Rinse Rinse
55
Rinse Rinse
09
PLATE WARMER
1. Load clean dishware to be warmed.
2. Select HEATED DRY.
3. Be sure the door is unlatched.
4. Slowly turn the Dial to PLATE WARMER.
5. Latch the door to start the cycle.
START DELAY
The START DELAY will allow you to delay the start
time of any cycle not on the Dial automatically for up
to 10 hours. Select your desired wash cycle and energy
options, then turn the Dial to the desired time. The
CYCLE ON light will come on.
Drying Options:
HEATED DRY. Available on all wash cycles
except RINSE & HOLD. Add approximately
31 minutes to cycle time.
ENERGY SAVER. Drying heater is turned
Main
Rinse Rinse
off. Dishes dry naturally.
Wash
Main
Rinse Rinse
Wash
Main
Rinse Rinse
Wash
Main
Rinse Rinse
Wash
Rinse Rinse
ENERGY SAVER
Turns all ENERGY OPTIONS off.
5