Input; Summary Of The Function Groups And Parameters - Pfaff 3119 Instruction Manual

11

Input

In the operational mode Input the values of the machine parameters can be altered, e.g. for
setting up the machine or for creating/modifying seam programs.
11

Summary of the function groups and parameters

.01
Operational mode Input (LED is off)
100 Operating staff
200 Specialists
300 Programming (see C C C C C hapter 11.05.02, 11.05.04 and 13.47.02)
400 Times (see Chapter 13.47.02)
500 Counters and speeds (see Chapter 13.47.02)
600 Service (see Chapter 13.47.02)
700 Sewing motor (see Chapter 13.47.02)
800 Access rights (see Chapter 11.04 and 13.47.02)
101 Knife suppression
102 Stop – needle thread fault
103 Display in Sewing mode
104 Display software version
105 Buttonhole type
106 Buttonhole model (see Chapter 11.05.03)
107 Maximum speed
108 Number of securing seam cycles (only for buttonhole model 2)
201 Deleting variable programs
202 Sub-class
203 PC connection
204 Bobbin thread monitor
205 Needle thread monitor
206 Copying programs
207 Multiple cuts
208 Enter knife length and cut overlap
209 Double cycle with offset stitch
210 Knife release
211 Number of finishing stitches
I off
II on
I off
II on
I Buttonhole model
II Speed
1 Raised purl seam, flat bar
2 Flat purl seam and bar
3 Raised purl seam and bar
4 Cycle 1, flat purl seam and bar
Cycle 2, raised purl seam and bar
5 Cycle 1, flat purl seam and bar
Cycle 2, raised purl seam, flat bar
1 –1/51 and –1/52
2 –2/51
3 –2/53 and –2/63
4 –3/51
5 –4/51
1 on
II off
1 on
II off
1 off
II on
1 Full number of stitches per cycle
2 Half number of stitches per cycle
Input
11 - 1