Programming Transmitters To The Vehicle - Pontiac G6 2010 Owner's Manual

Table of Contents

Advertisement

Q
(Lock): Press to lock all the doors. The interior
lamps turn off after all of the doors are closed. If enabled
through the Driver Information Center (DIC), the
remote lock feedback can be programmed to have the
horn chirp and/or the turn signals flash to confirm
locking. See "LOCK HORN" and "LIGHT FLASH" under
DIC Vehicle Personalization on page 4-47.
Q
Pressing
may also arm the content theft-deterrent
system. See Content Theft-Deterrent on page 3-16.
K
(Unlock): Press to unlock the driver door. If
pressed again within five seconds, all remaining
doors unlock. The interior lamps turn on and stay on for
20 seconds or until the ignition is turned on. If enabled
through the DIC, the remote unlock feedback can
be programmed to have the horn chirp and/or the turn
signals flash to confirm unlocking. See "UNLOCK
HORN" and "LIGHT FLASH" under DIC Vehicle
Personalization on page 4-47.
The high-beam headlamps, parking lamps, and back-up
lamps may turn on when
(Exterior) LIGHTS" under DIC Vehicle Personalization
on page 4-47.
K
Pressing
on the RKE transmitter disarms the content
theft-deterrent system. See Content Theft-Deterrent
on page 3-16.
3-4
K
K
is pressed. See "EXT
V
(Remote Trunk Release): Press and hold for
approximately one second to open the trunk. The trunk
will open using the transmitter when the vehicle
speed is less than 3 km/h (2 mph), when the ignition is
off, or when the vehicle shift lever is in P (Park).
L
(Vehicle Locator/Panic Alarm): Press to locate
the vehicle. The horn sounds three times and the
headlamps and turn signals flash three times.
Press and hold
is
sound the panic alarm. The horn sounds and the
headlamps and turn signals flash for 30 seconds.
L
Press
again to cancel the panic alarm.
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to the vehicle
will work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to the vehicle, all remaining transmitters
must also be programmed. Any lost or stolen transmitters
no longer work once the new transmitter is programmed.
Each vehicle can have up to four transmitters
programmed to it.
L
for approximately three seconds to

Advertisement

Table of Contents
loading

Table of Contents