Installation - Venturer PLV91237S52 Owner's Manual

INSTALLATION

INSTALLING / REMOVING THE STAND
WARNING: The LCD Display is very fragile, and must be protected at all times when installing /
removing the stand. Be sure that no hard or sharp object, or anything that could scratch or damage
the LCD display, comes into contact with it. Do NOT put pressure on the front of the unit at any time
because the screen could crack.
1. Disconnect any cables or cords connected to the unit.
2. Lay the unit down on a flat surface, so the back is facing up, making sure to place a soft cushioned
material (such as a pillow or thick piece of foam) beneath the screen.
3. Install / remove the two screws and then install / remove the STAND to / from the TV.
MOUNTING ON THE WALL
This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 75mm x
75mm mounting kit designed for flat-panel TVs (sold separately). Mount this unit according to the
directions included with the mounting kit.
Note:
Remove the stand before mounting the unit on the wall.
75mm
IMPORTANT
Screws must not project more than 8mm into the TV or damage may occur. For secure fixing make
sure at least 4mm of the screw thread is engaged.
8
PLV91237S52_IB_VEN_W020.indd 8 1/14/2011 18:21:18