Troy-Bilt 753 Service Manual page 17

underneath the unit. You will also be removing
the wheels and transmission from this position.
14.4. Using a ½ inch socket, remove the two screws
attaching the flap bracket to the frame. Remove
the flap bracket. See Figure 50.
14.5. Using a pair of needle nosed pliers, remove the
left rear cotter pin securing the lower brake rod
to the brake arm. See Figure 51.
Cotter Pin
14.6. Remove the lower brake rod from the brake arm.
Servicing the Troy-Bilt Wide Cut 33" Combination Mower
Mounting Screws
Flap Bracket
Figure 50
Lower Brake Rod
Figure 51
14.7. Using a pair of needle nosed pliers remove the
hair pin securing the shift link rod to the shift rod.
See Figure 52.
Hair Pin
14.8. Remove the tang retaining ring securing one of
the wheels. See Figure 53.
14.9. Remove the special washers and the wheel.
NOTE: Additional wheel spacing washers can
be added when required.
15
Shift Rod
Shift Link Rod
Figure 52
Tang Retaining Ring
Figure 53