Inspecting Burners - Desa VRL24NR Owner's Manual

Indicator
Light
Locks
ROOM
TEMP
System to
Prevent
LOCK
Accidental
Ignition
MANU
Turns
Burners
On or Off
Increases or
Decreases Room
Temperature in
AUTO Mode
Figure 35 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Manual Mode
1. Press POWER and LOCK buttons togeth-
er to turn on hand-held remote control.
2. Press MANU button to turn on fireplace.
3. Press POWER and LOCK buttons to-
gether to turn off fireplace.
Auto (Thermostatic) Mode
1. Press POWER and LOCK buttons togeth-
er to turn on hand-held remote control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by
pressing the TEMP + or - buttons.
4. Press POWER and LOCK buttons to-
gether to turn off fireplace.
Note: Do not leave hand-held remote in the
AUTO mode close to the fireplace. The radiant
Check pilot flame pattern and burner flame
patterns often.
PILOT FLAME PATTERN
Figure 36 shows a correct pilot flame pattern.
Figure 37 shows an incorrect pilot flame pat-
tern. The incorrect pilot flame is not touching the
thermocouple. This will cause the thermocouple
to cool. When the thermocouple cools, the
heater will shut down.
If pilot flame pattern is incorrect, as shown
in Figure 37
• turn heater off (see To Turn Off Gas to
Appliance, page 21 [thermostatically-
controlled model] or page 24 [remote-ready
models])
110021-01S
OPERATION
Digital
Display
Shows
AUTO
Temperature
SET
TEMP
and Settings
TEMP Turns Hand-
POWER
Held Remote
On or Off and
AUTO
ºC/ºF
Allows You
to Choose
the Manual
Setting
Selects AUTO
Mode
°C/°F Mode
Button

INSPECTING BURNERS

www.desatech.com
Continued
heat from the fireplace will turn off the fire-
place. Ideally, place hand-held remote in the
center of the room facing towards fireplace.
Note: Do not hold the hand-held remote for
a long time. Body temperature will affect its
operation in the AUTO mode.
Safety Features
When away from home for an extended period
of time or as a child safety feature to prevent
accidental ignition of the fireplace, the receiver
ON/OFF/REMOTE switch should be in the
OFF position.
Auto Shutoff Feature
1. If the average room temperature reaches
a range of 82° F (28° C) to 92° F (33° C),
the hand-held remote control will perform a
safety override and shut the fireplace off. This
feature is not available in MANU mode.
2. The receiver continuously receives sig-
nals from the hand-held remote to control
the room temperature. If the hand-held
remote is misplaced, obstructed or for any
reason cannot transmit to the receiver, the
receiver will shut off the fireplace. This will
occur in 8 or more minutes depending
upon location of remote transmitter and
strength of batteries.
Key Pad Lock Feature
This feature allows the user to lock/unlock the
keypad on the hand-held remote in the MANU
or AUTO mode to prevent inadvertent op-
eration (i.e. children operating the hand-held
remote control, etc.). The keypad is locked in
either on or off. Press the POWER and LOCK
buttons together to turn the unit on or off.
• see Troubleshooting, page 28
Pilot
Thermocouple
Burner
Figure 36 - Correct
Pilot Flame Pattern
(Natural Gas Pilot
Shown)
Thermocouple
Pilot
Burner
Figure 37 - Incorrect
Pilot Flame Pattern
(Natural Gas Pilot
Shown)
25