Port With Bayonet Catch - Hugyfot Housing User Manual

5. Port with bayonet catch

The front port bayonet catch is a secure and fast method to connect the dif-
ferent ports to the HUGYFOT Nikon D80 housing.
The port has a mark which has to be positioned opposite to the mark at the
left of the housing when mounting and demounting the port. To actually
close the port it has to be turned clockwise until the mark on the port is op-
posite to the mark on top of the housing. To demount the port it has to be
turned counter clockwise until the mark on the port is opposite to the mark
on the left of the housing.
When mounting the port, mind that it is held exactly in the middle of the
port mounting. Only then you can press the port so it slides nicely into the
port mounting. Check whether the port is closed properly before turning it
towards the marking on top of the housing. (secure position).
Third maintenance command:
The o-ring around the port can be removed from its groove by pressing it
with 2 fingers.
Port mounting, o-ring groove and bayonet catch have to be cleaned with a
wet cloth. Afterwards let everything dry.
Clean the inside of the portglas with water and soap. Never scrub it with a
cloth. Rinse it with fresh water and let it dry, or dry it with compressed air.
Grease the O-rings with HUGYFOT grease by gently pulling it through your
fingers without stretching it! Put it back into their grooves.
Hugyfot Housing for Nikon D80
B
C
A
8
When mounting the port,
A and C must be opposite
to each other. Make sure
that the port is held ex-
actly in the middle of the
port mounting. Then turn
the port clockwise until B
and C are opposite to each
other.
User manual