Table of Contents
Advertisement
2. Installation Requirements
1) To ensure proper operation make sure the 12 VDC power supply packed with your dome camera is
securely connected to an indoor 120 VAC outlet near the location of the dome. Power Supply is not
made for outdoor use. The use of a UL Approved extension cord is acceptable. Please consult your
local electrical codes for specific information.
2) Secure the included wall or ceiling (pendant) bracket to hold a minimum of five times the total weight of
your dome assembly. High winds can cause your dome assembly to be torn away from its location and
become a hazard. The included lag screws are provided for your convenience to mount the brackets
directly to a wood support beam or joist, and anchors for concrete block mortar joints. Your particular
installation situation should be carefully planned, and the proper mounting hardware should be used in all
cases. Please consult with a professional installer if you are not well acquainted with this type of
construction project.
3) Mark the location for the bracket mounting screws and drill the appropriate size holes for your
installation. Run wiring from the dome through the bracket, and attach the dome to the bracket exerting
equal pressure on the three screws around the neck of the dome. Connect the house wiring from the
control unit or DVR to the dome before mounting the dome if access to the dome wiring will be limited
after mounting. BE SURE TO MOUNT THE BRACKET SECURELY TO THE BUILDING OR POLE
STRUCTURE. Notice: If installed outdoors, please make sure all seals are tight to prevent water
from entering the dome. Caulk may be used around the building side of the wall or ceiling
bracket.
4
Advertisement
Table of Contents
