Horizontal Scanning - Security Labs SLC-177 Owner's Manual

Stay time for each preset of the tour group can be setup as 3 seconds, 5 seconds or 7 seconds.
[43]+[Call]--------- setting stay time for preset of the group is 3 seconds
[44]+[Call]--------- setting stay time for preset of the group is 5 seconds
[45]+[Call]--------- setting stay time for preset of the group is 7 seconds
If you wish to setup the stay time for preset as 7 seconds, input "45" on the control keyboard, and then
press the key [call].

11. Horizontal Scanning

Horizontal scanning can limit the range between the left and right observation the area between these
two presets.
Horizontal Scanning Setting
Horizontal scanning can be achieved through the scanning function of a tour group. That is to only setup
two presets of the tour group. When starting the tour group, the speed dome will scan between these two
presets.
For example, set #32 tour group as horizontal scanning, operation like as below:
a. #32 preset setting------- enter into setting state of #32 tour group---------input "32"，then press the key
[preset].
b. [2]+[Call] -------left limiting space of horizontal scanning
c. [6]+[Call]---------right limiting space of horizontal scanning
d. [32]+[Call]------- end setting #32 tour group, and the group is saved and run.
19
Start Horizontal Scanning
Call the number of tour group which has been set as horizontal scanning, and then the corresponding
horizontal scanning can be started.
If you want to start horizontal scanning of #32 tour group, input "32" on the control keyboard, then press
the key [call].
Stop Horizontal Scanning
Operate pan/tilt rotation by hand, the middle speed dome will stop the running horizontal scanning.
Horizontal Scanning Speed Setting
The method for setting horizontal scanning of the middle speed dome is the same as the method for
setting scanning speed of the tour group, the speed is divided into three grades you can setup randomly.
[40]+[Call]--------- setting scanning with low speed
11