Connecting External Components - JVC EXAD KW-AVX800 Instructions Manual

ELECTRICAL CONNECTIONS
To prevent short circuits, we recommend that you disconnect the battery's negative terminal and make all electrical connections before installing the unit.
• Be sure to ground this unit to the car's chassis again after installation.
Before connecting Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
:
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the aerial cord.
3
Finally connect the wiring harness to the unit.
Rear ground terminal
B A
See below.
2
2
* Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise
power cannot be turned on.
White with black stripe
Connecting the parking brake lead
Connect the parking brake lead to the parking brake system built in the car.
Crimp
connector
Parking brake
Parking brake switch
(inside the car)
A
Connecting the AV I/O cord
Video cords (not supplied)
CAMERA IN
2nd AUDIO OUT
L
R
VIDEO OUT
LINE IN
L
R
VIDEO IN
REVERSE
GEAR
SIGNAL
Reverse
lamp lead
4
* Required only when connecting a rear view camera to CAMERA IN plug.
Fan
3
USB cable (approx. 1.2 m)
Black
Yellow*
Red
Blue
15 A fuse
C
Blue with white stripe
Orange with white stripe
1
Brown
Light green
9
White Gray with black stripe
Le speaker (front)
Parking brake lead (light green)
To metallic body or
chassis of the car
To rear view camera
L
R
L
R
Audio/video cords
(not supplied) 2nd monitor
(KV-MR9010, etc.)
Navigation System
or playback source
Reverse lamp
Reverse gear signal
extension cord* 4
REVERSE
Crimp
GEAR
connector
SIGNAL
To car battery To reverse lamp
• You cannot connect a computer to the
USB ( ) terminal of the unit.
* 1 Not included with this unit.
To metallic body or
1
chassis of the car
2
To alive terminal in the fuse block connecting to
2
the car battery (by passing the ignition switch)
3
To an accessory terminal in the fuse block
(POWER ANTENNA)
(REMOTE OUT)
6
(ILLUMINATION)
7
(TEL MUTING)
(PARKING BRAKE)
Green with black stripe
Gray
Right speaker (front)
B
Connecting the external amplifiers
You can connect amplifiers to upgrade surround system in the car compartment.
• Connect the amplifiers to 5.1-ch analog discrete output plugs to enjoy multi-channel source.
• After you have connected the center speaker, make sure to activate the center speaker; otherwise,
no sound comes out of the connected center speaker, see page 54 of the INSTRUCTIONS.
• You can supply the power to the amplifiers by connecting the remote leads (blue with white stripe) of
this unit and amplifiers. (To connect more than one amplifier using the remote leads, Y-connectors
need to be separately purchased.)
• Disconnect the speakers from the unit, and connect them to the amplifier. Leave the speaker leads of
the unit unused.
INPUT
Front
JVC
L
speakers
Amplifier
R
* 5
Rear
JVC
speakers
Amplifier
5
*
5 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place
*
uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to
do so may cause damage to the unit.
C

Connecting external components

You can connect external components in series as shown in the diagram below.
• All the components, adapters or signal cords need to be purchased separately.
Cordless CAUTION:
headphones Before connecting the external components, make sure that the unit is turned off.
(KS-HP2)
• To use JVC CD changer, Apple iPod or JVC D. player, set "External Input" to "Changer/iPod/
D. Player" (see page 56 of the INSTRUCTIONS).
• To use other external components via KS-U57 or KS-U58, set "External Input" to "External" (see page
56 of the INSTRUCTIONS).
To disconnect the connector
Hold the connector top
tightly (1), then pull it out
(2).
• iPod is a trademark of Apple Inc., registered in the
U.S. and other countries.
2
Ignition switch
* 1
* 1
To automatic antenna
4
if any (250 mA max.)
5
To the remote lead of other equipment (200 mA max.)
To car light control switch
To cellular phone system
To parking brake of the car (see below.)
8
Crimp connector
Purple with black stripe
Green
Le speaker (rear)
L
R
INPUT
L L
R
R
L R R L
JVC Bluetooth
adapter
or
or
CD changer jack
or
or
* 6 Audio cord (not supplied) is required.
USB device
Fuse block
Purple
Right speaker (rear)
INPUT
Center
JVC
speaker
Amplifier
* 5
JVC
INPUT
Subwoofer
Amplifier
5
*
JVC CD changer
KS-PD100
KS-PD500
External component
* 6
KS-U57
with RCA pin jacks
External component
KS-U58
with stereo-mini jack