Advertisement
A total outdoor surveillance solution in one stylish unit
Super Dynamic II camera, 8x variable-focal lens, Fan/Heater, Protective Housing, Pan/Tilt bracket,
Mounting Arm, Mounting Plate, and Mounting Adapter Box are all included.
Sun Shield
8x Variable-focal Lens
Mounting Plate
Mounting Adapter Box
Tilt Bracket
Mounting Arm
6
Blue LED
(Both sides)
Tilt Lock Screw
Rear Cover
Protective Housing
Pan Lock Screw
Blue LED
(Both sides)
Pan Bracket
D e s i g n
Invisible Cable; Clean, Simple Lines
Simple Installation Procedure
Both camera and wall cables are
1
concealed inside the bracket.
3-way Installation
Use four screws (option) to attach
1
Cables through wall with Mounting Adapter Box
Mounting Adapter Box to wall.
3
Cable in wall
2
Using Conduit (Flexible pipe) with Mounting Adapter Box
Pass the camera cable through the
Mounting Arm and attach to wall cable.
5
Cable in conduit
3
Direct mount without Mounting Adapter Box
Use two screws provided.
Cable in wall, connected
directly to Mounting Plate*
(* The four screws required to attach the Mounting
Plate to the wall are not provided)
Equipped with Monitor output connector
The opening can be either
on the left or the right side
Since a small LCD monitor
(option) can be attached to
The Mounting Plate
the monitor output connector
opening can be either
(3.5mm in diam. Mini jack),
on the left or the right.
camera angle and focus can
However, it is best if
be checked on the spot.
one side is tightly
pressed against a wall.
Flexible camera angle settings
Fits neatly above the existing junction box.
The bracket allows the camera to Tilt +30° ~ –90° and pan,
Installation is simple because the Mounting Adapter Box
making it possible to freely adjust the camera angle.
and Mounting Plate are designed to be mounted directly
above the existing junction box.
Tilt
Pan
Photographs were taken for the purpose of explanation; actual images may differ.
Attach Mounting
Adapter Box to wall.
Attach Mounting Plate
2
to Hinge.
Attach Camera to
Mounting Arm.
Set Hinge Screw provided to allow
opening and closing
4
Secure Mounting Plate.
Attach Trim Covers
Use four screws provided to attach
Mounting Plate.
6
Finished !
7
Advertisement
