Rheem 612 Owner's Manual And Installation Instructions page 23

bath fill water volume display panel – The selected bath fill water volume is displayed in litres on all Deluxe
controllers.
The selected bath fill water volume is displayed whenever the Bath Fill mode is on
(refer to
adjusted and the Bath Fill mode is off.
If the bath fill water volume is being adjusted and the Bath Fill mode is off, then the
bath fill water volume display panel goes blank three (3) seconds after a BATH FILL
VOLUME button is last pressed.
At other times, if the Bath Fill mode is off, the bath fill water volume display panel
remains blank.
bath fill indicator light – this light in the display panel will glow when the bath fill water volume is displayed.
BATH FILL TEMPERATURE i (up button) – The up button increases the bath fill water temperature setting
(refer to
Mode"
BATH FILL TEMPERATURE j (down button) – The down button decreases the bath fill water temperature
setting (refer to
"Bath Fill Mode"
BATH FILL VOLUME i (up button) – The up button increases the bath fill water volume setting in
increments of 10 litres up to 500 litres. A further setting of 990 litres can be selected.
BATH FILL VOLUME j (down button) – The down button decreases the bath fill water volume setting from
990 litres to 500 litres and in increments of 10 litres from 500 litres down to 10 litres.
DELUXE CONTROLLER
bath fill water volume
display panel
BATH FILL
operating light
assistance call
button
BATH FILL
button
BATH FILL
VOLUME
i i up button
BATH FILL
VOLUME
j j down button
Deluxe controller type
K = Kitchen
B1 = Bathroom1
B2 = Bathroom2
"Bath Fill Mode" on page 32) or when the bath fill water volume is being
"Temperature Adjustment – Deluxe Controllers"
on page 32).
"Temperature Adjustment – Deluxe Controllers"
on page 32).
operating BATH FILL
light indicator light
2 3 0
BATH (l)
BATH FILL
BATH FILL
VOLUME
Rheem
K
Bath Fill 1. 2.
Bath Bath
Water Fill
Volume Temp
Set Bath Fill Water Volume
and Temperature
Hot Water 1.
ON/OFF
Press
TEMPERATURE CONTROL – DELUXE
ACTIVE temperature
light display panel
ACTIVE
4 2
°C
ON/OFF
BATH FILL
TEMPERATURE
3. 5. 7.
Bath Fill
BATH FILL BATH FILL
completed
(automatic)
Press Bath Press Bath
Fill Button Bath Fill Button Fill Button
(Red light on) (Red light flashes)
(red light off)
4. Open hot tap 6. Close hot tap
2. 3. 4.
ACTIVE Adjust Open hot
Light on Temperature tap
23
on page 27 and to
on page 27 and to
speaker
i up
button
j down
button
ON / OFF
operating light
ON / OFF
button
BATH FILL
TEMPERATURE
i i up button
BATH FILL
TEMPERATURE
j j down button
brief Deluxe controller
operating instructions
bath-fill mode and
hot water mode
"Bath Fill