Standalone Reconfiguration - Canoga Perkins 2240 User Manual

Canoga Perkins

4.12 Standalone Reconfiguration

To access the circuit board on a standalone unit, the enclosure cover must first be
removed by loosening the six screws on the sides of the unit. Next, unplug the
power supply connector from the PC board, and remove the two screws holding
the rear panel in place.
The entire circuit board may now be removed by loosening the eight mounting
screws. The interface board may now be changed as outlined in Section 4.11,
"Interface Reconfiguration."
The rear panel supplied with the new interface must also be exchanged with the
original rear panel. The unit may then be assembled in the reverse order of the
disassembly.
94