Kenwood TK-780 Service Manual page 18

TK-780
7-2. Channel Setting Mode
Each channel can be setup in its action mode by using
the panel keys.
• Pressing [ ] while "SELF PROG" is displayed will
change to channel setting mode.
• Press [D] to select a setup item, then press [Channel up/
down] to change the selection.
• By pressing [C], the displayed information is stored in
memory, and the next item appears. By pressing [D], the
displayed information is not stored in memory, and the
next item appears.
• Press [ ] to return to the original display ("SELF PROG").
The setup items fro channel setting mode are listed be-
low.
Setup function Display
(3 character)
Channel selection CH or GRP
RX frequency RXF
RX signalling RXS
TX frequency TXF
TX signalling TXS
Scan del/add SCN
RF power PWR
Beat shift SFT
Wide/Narrow W/N
Compander CMP
18
REALIGNMENT
Remarks
[CALL] : Switches frequency on/off
[B] : Changes the step value
between 5kHz, 6.25kHz, and
1MHz
[CALL] : Switches between off,
QT, and DQT.
[B] : Switches between 1 step
and standard
[A] : Switches between DQT
normal and invert
Same as RX frequency
Same as RX signalling
DEL/ADD
HIGH/LOW
YES/NO
WIDE 5k/WIDE 4k/NARROW
ON/OFF
7-3. Flow Chart
Self programming
mode
[ ]
[ ]
Channel setting
mode
[C]
[ ]
RX frequency
[CALL]
[C]/[D]
[ ]
RX signalling
[CALL]
[C]/[D]
[ ]
TX freuency
[CALL]
[C]/[D]
[ ]
TX signalling
[CALL]
[C]/[D]
[ ]
Scan delete/add
[C]/[D]
[ ]
RF power high/low
[C]/[D]
[ ]
Beat shift yes/no
[C]/[D]
[ ]
Wide/Semi wide/Narrow
[C]/[D]
[ ]
Compander
[C]/[D]
7-4. Memory Reset Mode
You can clear all settings you made in self programming
mode, or you can return to the original display.
• Press [A] while "SELF PROG" is displayed will change
the display to "CLEAR NO?".
• Press [Channel up/down] to change the display between
"CLEAR NO?" and "CLEAR YES?".
• When "CLEAR YES?" is displayed, pressing [A] will set
all data to default, and "ALL CLEAR" will appear on the
display. Press [A] again to display "SELF PROG".
• When "CLEAR NO?" is displayed, pressing [A] will can-
cel the reset, and "SELF PROG" will be displayed.
Channel selection Group selection
[D]
OFF
[CALL]
OFF QT DQT N DQT I
[A]
[CALL]
[CALL]
OFF
[CALL]
OFF QT DQT N DQT I
[A]
[CALL] [CALL]