HP 2000 Maintenance And Service Manual page 71

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
WLAN module (see
●
Keyboard (see
●
Top cover (see
●
USB board (see
●
Power connector cable (see
Remove the display assembly:
1. Disconnect the display panel cable (1) from the system board.
2. Release the wireless antenna cables from the clips (2) built into the base enclosure.
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other computer
components.
3. Remove the four Phillips PM2.5×6.0 screws (3) that secure the display assembly to the
computer.
4. Remove the display assembly (4).
Battery on page 39), and then remove the following components:
Optical drive (select models only) on page
WLAN module on page
Keyboard on page 49)
Top cover on page 51)
USB board on page 58)
Power connector cable on page
40)
43)
59)
Component replacement procedures 63