Table of Contents
Advertisement
SETTING UP
Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
POWER switch
Input 3
(side) will take
priority over
EXT3 (back) if
both connections
are used at the
same time.
Switching on
If the RED LED is unlit check that the mains plug is connected
to the power supply and press the
left side of the television to switch the television on. If the
picture does not appear press
take a few moments.
To put the television into Standby press
control. To view the television press
take a few seconds to appear.
Using the remote control
To set up the television you will now need to use the on-screen
menus. Press M on the remote control to see the menus.
The menu bar at the top of the screens will show six different
topics shown in symbols. As each symbol is selected by
C
c
pressing
or
on the remote control, its respective options
will appear below.
B
To use the options, press
move up and down through them and Q,
required choice. Follow the on-screen instructions. The
functions of each menu are described in detail throughout the
manual.
GREEN LED – On timer
!
(POWER) button on the
1
on the remote control, it may
1
on the remote
1
again. The picture may
b
and
on the remote control to
C
c
or
to select the
RED LED – Standby
GREEN LED – Power on
Using the controls and connections
To alter the volume press –
To alter the programme position press
I
i
Press MENU and
,
,
options.
Press MENU to finish.
An S-video cable provides better picture performance than a
composite video cable. If you connect an S-video cable to
EXT3, be sure to disconnect the standard (composite) video
cable or the picture performance will be unacceptable.
To select the external input, press
input source is selected as described on page 27.
Please always refer to the owner's manual of the equipment to
be connected for full details.
12
Standby
HDMI3
INPUT
2
+.
b p B
.
U
u
or
to control the sound and picture
o
until the appropriate
INPUT 3
(EXT3)
Advertisement
Table of Contents
