Jeep Liberty 2010 Owner's Manual page 37

Hide thumbs Also See for Liberty 2010:
Table of Contents

Advertisement

36 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
(Customer-Programmable Features" in the "Electronic
Vehicle Information Center (EVIC)," in Section 4 of this
manual.
Auto Up Feature with Anti-Pinch Protection — If
Equipped
On some models, the driver's and front passenger's (if
equipped for passenger side) power window switches
have an "Auto Up" feature. Pull the window switch up to
the second detent, release, and the window will go up
automatically.
To stop the window from going all the way up during the
Auto Up operation, push down on the switch briefly.
To close the window part way, pull the window switch
up to the first detent and release when you want the
window to stop.
For vehicles not equipped with the Electronic Vehicle
Information Center (EVIC), the power window switches
will remain active for 45 seconds after the ignition switch
is turned to the LOCK position. Opening either front
door will cancel this feature.
For vehicles equipped with the EVIC, the power window
switches will remain active for up to 10 minutes after the
ignition switch is turned to the LOCK position. Opening
either front door will cancel this feature. The time is
programmable. For details, refer to "Delay Power Off to
Accessories Until Exit," under "Personal Settings
(Customer-Programmable Features)" in the "Electronic
Vehicle Information Center (EVIC)," in Section 4 of this
manual.
NOTE:
• If the window runs into any obstacle during auto-
closure, it will reverse direction and then go back
down. Remove the obstacle and use the window
switch again to close the window.

Advertisement

Table of Contents
loading

Table of Contents