Poulan Pro PR624ES Owner's Manual page 6

ASSEMBLY / PRE-OPERATION
INSTALL TRACTION DRIVE CONTROL ROD
(See Figs. 3 and 4)
The traction drive control rod is installed on the snow thrower.
1. Remove plastic tie securing rod to lower handle.
2. With top end of rod positioned under left side of control
panel, push rod down and insert top end of rod into hole
in drive control bracket. Secure with retainer spring.
TRACTION DRIVE
TRACTION DRIVE
CON TROL LEVER
DRIVE
CONTROL
BRACKET
PLASTIC TIE
CONTROL ROD
VINYL
SLEEVE
FIG. 3
RETAINER
SPRING
TRACTION
DRIVE
CON TROL
ROD
FIG. 4
INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
1. Retrieve vinyl sleeve and spring from bag of parts and
retrieve the auger control rod from carton chute tray.
Slide straight rod end through the small hole in the
vinyl sleeve. Using the long hook end of the spring,
hook spring in hole #4 in rod. (See Fig. 5).
2. Hook end of spring into control arm with loop opening
up as shown. (See Fig. 5).
3. With top end of rod positioned under right side of control
panel, push down on rod and insert end of rod into hole
in auger control bracket. Secure with retainer spring.
CONTROL
VINYL
ARM
SLEEVE
AUGER CONTROL ROD
6
LOOP
OPENING
UP
FIG. 5
AUGER
CONTROL
RETAINER
LEVER
SPRING
AUGER
CONTROL
BRACKET
FIG. 6
AUGER
CONTROL
ROD