Advertisement
Your scale has been pre-configured at
the factory and should not require
configuration for use in most applications.
In the event that the factory settings
do not meet the requirements of your
application, the following describes
the steps to configure the scale.
To Enter Configuration:
1. Press the ON/ZERO/OFF key to
turn on the scale.
2. Press and hold the ZERO key for
3 seconds.When the display shows
Set , release the ZERO key to
enter Configuration.The display
will change to Unit .
DISPLAY
Lo
Configuration
Display Messages
Automatic Shutoff
1. With the display showing Unit ,
press the ZERO key.The display
will change to AOFF .
2. Press the MEMORY key to begin
selection of the automatic shut-off
time (in seconds).The display will
change to 120 .
3. Press the ZERO key to toggle
through the selections, 120, 180,
240, 300, or OFF.
4. When the desired time value is
displayed, press the MEMORY key.
The display will change to AOFF .
5. Press the ZERO key to change the
display to End to store this
setting.
6. Press the MEMORY key back to
weighing mode.
MEANING
Low battery indication
2
E
Under Zero
Over Zero or
Over Capacity
5
prom Error
Hide quick links:
Advertisement
