Advertisement
Battery
The scale can use a "9V" size Alkaline
battery (not included). If you wish to
operate the scale from a battery, you
must first obtain and install the battery.
The battery is contained in a holder
inside the scale.Access is via a removable
panel on the right end of the bottom of
the scale.
Installing The Battery
1. Turn the scale over so that the display
is facing down and place it upside
down on a flat level surface, such as a
table or bench.
2. Locate the battery door on the
bottom of the scale.
3. Remove the battery door by pushing
in on the "arrow" and sliding the
battery door in the direction of the
arrow.
4. Slide the battery door about 1/2 inch,
lift and remove exposing the battery
snap connector.
5. Connect the snap connector to a
9 volt battery and place the battery in
the holder.
6. Place the battery door on the scale
and slide it the "opposite" direction of
the arrow until you hear it click and
lock in place.
Installation
continued
Low Battery
When the battery is near the point it
needs to be replaced, a low battery
indicator Lo will be displayed. If the
battery voltage drops too low for
accurate weighing, the scale will
automatically shut off and you will
be unable to turn it back on.When the
low battery indicator Lo is displayed,
the operator should replace the battery
or remove the battery and plug-in the
9VDC adapter.
3
Hide quick links:
Advertisement
