Cleaning The Guide Bar, Lubricating The Sprocket Nose - Dolmar PS-410 Instruction Manual

E
‑ All cutters must be sharpened to the same angle, 30°. Dif‑
ferent angles result in a roughly, irregularly running chain,
increase wear and tear and cause chain beakage.
‑ The 85° front rake of the cutter results from the cut depth of
the round file. If the proper file is used in the right manner,
the correct front rake will be obtained automatically.
30°
G
‑ The file holder makes file guidance easier. It is marked for
the correct 30° sharpening angle (keep the marks parallel
with the chain when filing, see illustration) and limits the
cut depth to the correct 4/5 of the file diameter. See "Acces‑
sories" for the order number.
Cleaning the guide bar,
lubricating the sprocket nose
CAUTION:
Protective gloves must be worn!
J
F
Files and how to work with them
‑ Sharpen using a special file holder with a saw chain round file.
File the first cutter half with a 4.8 mm dia. round saw‑chain
file, then switch to a 4.5 mm dia. file. Normal round files
are not appropriate for this work. See "Accessories" for the
order number.
‑ The file should cut only when pushed forwards (arrow).
Lift the file when leading it backwards.
‑ First sharpen the shortest cutter. The length of this cutter
is then the standerd for all other cutters of the chain.
‑ Always guide the file horizontally (10
4/5
H
‑ After having sharpened the chain, the height of the depth
limiter must be checked by means of a chain gauge. See
"Accessories" for the order number.
‑ Correct even the smallest excess height with a special flat
file (H). See "Accessories" for the order number.
‑ Round off the front of the depth limiter (I).
Regularly inspect the bearing surfaces of the guide bar for dam‑
age, and clean them with a suitable tool.
If the saw is used intensively it will be necessary to lubricate
the return sprocket bearings regularly (once a week). To do this,
first thoroughly clean the  mm hole at the tip of the guide bar,
and then press in a small amount of multi‑purpose grease.
Multi‑purpose grease and grease guns are available as
accessories.
Multi‑purpose grease
Grease gun
to the guide bar).
o
I
(order no. 944 360 000)
(order no. 944 350 000)
7