Setting Program Start Times - Toro TMC-212 User Manual

373-0319 TCM 212 Doc2 12/20/04

Setting Program Start Times

Turn the control dial to the
position.
Check the
PROGRAMS
reposition the switch to select the desired program.
Program start time number 1 will begin flashing. The
current program start time or OFF will be displayed
for start time number 1. To select a different program
start time number, press the +/
ton until the desired number is flashing.
Note: The numbers (1–4) shown at the top of the display
designate program start times and should not be con-
fused with station numbers. The station numbers will be
shown at the bottom of the display when setting station
run time.
Press the button. The hour digit(s) or OFF will
NEXT
begin flashing.
Note: To remove the start time, select OFF by
pressing the +/ and –/
ON
time, and continue at step
To set the hour (and
AM
–/ button until the desired hour is flashing.
OFF
Press the button. The minute digits will begin
NEXT
flashing.
To set the minutes, press the +/
until the desired minute is flashing.
Press the button. The next program start time
NEXT
number will begin flashing.
12:30 PM Page 27
PROGRAM START TIME
switch setting. If necessary,
or the –/ but-
ON OFF
buttons at the same
OFF
.
/ ), press the +/ or the
PM ON
or –/ button
ON OFF
3 9
2
12
4 5
1
To select another start time number, press the +/
or the –/ button until the desired start time num-
OFF
ber is flashing.
10. To set, change or remove a program start time for
the start time number selected, repeat all of the
steps starting at step .
11. To set program start times for another program,
repeat all of the steps starting at step
Return the control dial to the
3 5 7 9
6 7
4 6 8
3 5 7 9
ON
.
position.
RUN
27