Cisco MDS 9500 Series Overview page 44

Services Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 1-28
Figure 1-28
1
2
LEDs on the 18/4-Port Multiservice Module
Table 1-15
Table 1-15
LED
Status Green
Cisco MDS 9500 Series Hardware Installation Guide
1-44
shows the MSM-18/4 module.
18/4-Port Multiservice Module
1
Status LED
1-Gbps/2-Gbps/4-Gbps Fibre Channel ports
describes the LEDs for the 18/4-port Multiservice module.
LEDs for the Cisco MDS 9000 Family 18/4-Port Multiservice Modules
Status Description
All diagnostics pass. The module is operational (normal
initialization sequence).
Orange One of the following occurs or occurred:
• The module is booting or running diagnostics (normal
initialization sequence).
The inlet air temperature of the system exceeded the
•
maximum system operating temperature limit (a minor
environmental warning). To ensure maximum product
life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red One of the following occurred:
The diagnostic test failed. The module is not operational
•
because a fault occurred during the initialization
sequence.
• he inlet air temperature of the system exceeded the safe
T
operating temperature limits of the card (a major
environmental warning). The card shut down to prevent
permanent damage.
2
4
3
Gigabit Ethernet ports
4
Link LEDs
Chapter 1 Product Overview
3
OL-21516-01