Security Tronix ST-PTZ-RC User Manual page 7

f. To run a Pattern Tour press RUN and the PT Dome
Controller's will display
g. Press RUN again to stop the Pattern Tour.
Setting Camera Speed
a. For camera travel time (i.e., camera rotation from one Preset Position to another
either manually or by running Pattern Tour) four separate speed settings are
available:
 S1 = 8, S2 = 40, S3 = 51 and S4 = 63
 S1 is the slowest and S4 is the fastest
b. Speed can be set by pressing SPEED then S1, S2, S3 or S4 and ENTER
c. For Pattern Tour the default settings are 63 for camera travel speed and
approximately 8 seconds dwell time (time the camera will remain on a particular
Preset Position). Other speed settings may be made during the Pattern Track Setup
Mode described above.
Functions
The UP, DOWN, LEFT, and RIGHT buttons control the corresponding
movement of the PTZ camera.
The ENTER button serves as a movement "stop" key. It is also a "confirm" key when
inputting a number.
Numeric keys 0 through 9 are number input buttons.
The C button is to backspace during number input.
The -/-- button is to enter into the "plus 10" mode if you want to enter a number
greater than 10 (from 0 to 255). It can also place you into "normal" mode where you
can only input numbers from 0 through 9.
Pressing the ESC button will put the system into the address input mode.
The CAM button places the system into the address input mode.
7
PrUN