Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Security Tronix ST-PTZ-RC
Summary of Contents for Security Tronix ST-PTZ-RC
-
Page 1: User Manual
USER MANUAL ST-PTZ-RC Infrared Remote PTZ Controller v1.2 8/22/11... -
Page 2: Package Contents
The PT Dome Controller requires a 12VDC 1A power supply (not supplied) such as the Securitytronix ST-PS12VDC1A. PRODUCT DESCRIPTION The ST-PTZ-RC is a consumer grade pan, tilt, zoom (PTZ) controller designed for PTZ dome cameras. The ST-PTZ-RC comes with one PT Dome controller allowing PTZ control of up to 255 PTZ cameras. SPECIFICATIONS ST-PTZ-RC Specifications (Typical) 1. -
Page 3: Unpacking And Handling
PT Dome Controller and the camera’s communication and power lines, power supplies and video lines and any high voltage equipment and/or cables. b. Do not open up or dismantle the ST-PTZ-RC or the PT Dome Controller’s cases. There are no serviceable parts inside the unit. -
Page 4: Wiring Connections
Infrared Remote Controller’s UP/DOWN buttons and the baud rate via the LEFT/RIGHT buttons. Select the desired protocol and/or baud rate then press ENTER to save and confirm. The ST-PTZ-RC default protocol and baud rate settings are PELCO-D at 2400BPS. Set Target Camera Address a. - Page 5 A- - - A- 26 d. Within any mode you can press the ESC button and the system will return you to the address mode. e. If you only want to change an address number below 10, you only need to press the appropriate numeric key one time.
- Page 6 Set Up and Run Pattern Tour A Pattern Tour allows the camera to automatically track a select group of Preset Positions. a. Pressing PATTERN once puts the ST-PTZ-RC into Pattern PStA Track Setup Mode. The PT Dome Controller will display b.
- Page 7 To run a Pattern Tour press RUN and the PT Dome PrUN Controller’s will display g. Press RUN again to stop the Pattern Tour. Setting Camera Speed a. For camera travel time (i.e., camera rotation from one Preset Position to another either manually or by running Pattern Tour) four separate speed settings are available: ...
- Page 8 The SHOT button calls the desired Preset Position. HOME is for a Home Preset Position. A and B are Preset Positions that can serve as Left and Right Limiting Positions allowing the camera to automatically scan between the two positions. The PRESET button is to set a preset point.
-
Page 9: Troubleshooting Tips
Pressing SETUP allows the configuring of the ST-PTZ-RC’s protocol and baud rate. 7. TROUBLESHOOTING TIPS a. The ST-PTZ-RC is not controlling the camera at all – (i) be sure the R485 connections between the ST-PTZ-RC and the camera are using the same polarities; (ii) check to see if the correct baud rate has been set with the camera;...