Table of Contents
Advertisement
Cleaning & Maintenance
To service electric fireplace, it may be necessary to remove it from the mantel or en-
closure in which it is installed. Allow unit to cool completely before cleaning or servic-
ing.
• Cleaning Firebox
1. Open control panel door by pressing on right side. a spring magnet will push door
forward. Pull door down to open.
. Remove two () screws holding front trim in place. Pull gently to remove trim.
Figure 9. There are magnets on the lower portion of trim. Figure 9
3. With gloves and safety glasses in place, remove four (4) screws from glass re-
tainer brackets. Figure 9
4. Carefully remove front glass and brackets. Figure 10
5. Using a brush vacuum attachment, gently clean compartment.
6. After cleaning compartment, replace front glass, brackets and trim.
Trim
• Replacing Log
1. Follow Steps 1 through 4 of 'Cleaning Firebox'.
. Remove screws from each side of log securing log to sides
and remove log. Figure 11
3. Install new log using screws removed in Step .
4. Replace front glass and brackets.
5. Replace trim.
• Replacing Ember Strip
1. Follow Steps 1 and of 'Replacing Log'.
. Locate ember LED strip, Figure 11. Disconnect wire (right
side).
3. Remove ember LED strip by squeezing top of standoffs
and discard.
4. Connect new ember LED strip using existing standoffs.
5. Reconnect wire to LED strip.
10
WARNING:
ways
power and allow
the heater to cool before
performing any cleaning,
maintenance or relocation
of this heater. Turn controls
to OFF and remove plug
from outlet or turn off circuit
breaker to heater.
FP2573
replace log
Al-
disconnect
68D5301
Hide quick links:
Advertisement
Table of Contents
