Assembly - Craftsman 172.276750 Operator's Manual

DESCRIPTION cont.
This Random Orbit Sander has the following features cont.:
6. On/Off rocker switch is conveniently located for easy control. Sealed to keep out
dust for long life.
7. Hook and Loop Backing Pad for easy attachment of hook and loop type sanding discs
with pre-punched holes.
8. High impact-resistant housing helps protect tool from damage and reduces weight.
9. Built-in Dust Collection System Dust bag assembly with dual dust ports collects dust
from work surface through holes in backing pad and sanding disc. Use either the dust
bag, or attach a 1 1 / or 2 1 / -inch vac hose and wet / dry vac (sold separately) for
4 2
dust collection. Helps keep work surface area clean and extends life of sanding disc.
10. Permanently lubricated 100% ball bearings for smooth operation and long life.
Comfort Grip Handle
Fig 2
On/Off
Rocker Switch
Vac Adapter with
Dual Dust Ports
5-in.
Hook and Loop Backing Pad
PRODUCT SPECIFICATIONS
No-load Speed 5000-12000 OPM (orbits per minute) variable speed
Rating 120 Volts, 60 Hz AC
Input 3.0 Amps
Orbit Diameter 1/8-in.
Sanding Disc Size 5-in. Diameter
Paper Type Hook and Loop Discs with Pre-Punched Holes
12

ASSEMBLY

WARNING:
!
when you are assembling parts, making adjustments, installing or removing
sandpaper, cleaning or when it is not in use. Disconnecting the sander will prevent
accidental starting, that could cause serious personal injury.
INSTALLING THE SANDPAPER (See Figs. 3)
ALWAYS inspect the sandpaper before installing. DO NOT use if broken or defective.
1. Unplug the sander.
WARNING:
!
starting causing possible serious personal injury.
NOTE: Remove dust bag assembly when installing sandpaper. ALWAYS remember
Variable Speed Dial
to reattach the dust bag assembly before beginning sanding operation
(see page 15, Fig. 6).
2. Align the holes in the sanding disc with the holes in the hook and loop backing pad.
NOTE: Holes in sanding disc must line up with holes in the backing pad in order for
the dust collection feature of the sander to function properly.
3. Press the sanding disc against the backing pad as firmly as possible.
NOTE: For best adhesion, we recommend that you clean the backing pad and the
sanding disc backing occasionally by brushing them lightly with a small brush.
Fig 3
Dust Bag
Assembly
Your sander should NEVER be connected to the power source
Failure to unplug the sander could result in accidental
Sander
Backing Pad
5-in. Hook and Loop Sanding
Disc with Pre-Punched Holes
13