Table of Contents
Advertisement
Battery
WARNING
• When jumping from a booster battery make final (negative) connection at engine frame.
• Do not jump start or charge a frozen or damaged battery. Unplug charger before connecting or
disconnecting cables to the battery. Never lean over battery while boosting, testing, or charging.
The battery in a Husqvarna vehicle is a 12-volt, low-maintenance battery that requires infrequent checks (Figure
29). Electrolyte level should be checked semiannually.
222
Figure 29 Battery
1.
Turn the key switch to the OFF position and remove the key. Place the Forward/Reverse handle in the NEUTRAL
position. Chock the wheels.
2.
Access the engine compartment. See WARNING "For vehicles with cargo beds..." in General Warnings
on page 8.
2.1. Remove the driver-side seat.
3.
Disconnect battery. See Disconnecting the Battery – Diesel Vehicles on page 9.
4.
Use a flat-blade screwdriver, and carefully remove the battery cell caps from the battery. See following
WARNING.
WARNING
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and
rubber gloves when working on or near batteries.
5.
Carefully check the electrolyte level and add distilled water if necessary. Do not fill the battery cells above
the designated fill line. Replace battery cell caps.
6.
Clean both battery terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon
(3.8 L) of water). Rinse thoroughly. Do not allow this solution to enter the battery. Be sure terminals are tight.
Let the terminals dry and then spray them with Battery Terminal Protector Spray (P/N 603 00 00-03). See
Connecting the Battery – Diesel Vehicles on page 9. See following WARNING.
Page 44
HUV 5420 DX
Homologated Diesel Vehicle for Europe Owner's Manual
R
1. Level Indicator 2. Cap 3. Plates
Electrolyte level at least 1/2 inch (13 MM) above plates or to level
indicator.
22
Figure 30 Battery Electrolyte Level
Advertisement
Table of Contents
