Table of Contents
Advertisement
The Wireless - Wi-Fi Protected Setup Tab
This screen allows you to configure the WPS settings for the Access Point. WPS (Wi-Fi Protected
Setup) was designed to help standardize and simplify ways of setting up and configuring
security on a wireless network by typing a PIN (numeric code) or pushing a button (Push-
Button Configuration, or PBC).
Wi-Fi Protected Setup
•
Option 1—This method can be used only if the client device has the WPS push button.
Press the WPS button of the client device and then click the button on the right.
•
Option 2—The user has to give the PIN number which is founded in the utility of the
client device. Enter the number and click Register button.
•
Option 3—Enter the PIN number shown on the label at the bottom of the Access Point
into the utility of client device.
Change these settings as described here and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen.
The Wireless - VLAN & QoS Tab
This screen allows you to configure the Qos and VLAN settings for the Access Point. The QoS
(Quality of Service) feature allows you specify priorities for different traffic. Lower priority traffic
will be slowed down to allow greater throughput or less delay for high priority traffic. The
WAP4410N User Guide
Configuring the Wireless-N Access Point
The Wireless - Wi-Fi Protected Setup Tab
28
Advertisement
Table of Contents
