Heat & Glo Bravo Owner's Manual page 44

OPTION D: Flush Wall Finish with Luxor Surround
Kiva-style fi nished in a straight wall (see Figure 13.8).
Figure 13.8 Flush wall installation with Luxor Surround
• Unit is installed using framing dimensions found in Figure
5.2.
• Do not use nailing tabs provided on appliance sides for
Option D.
• Nailing tabs are attached to the top of the appliance.
Install nailing tabs using screws on upper appliance sides
(see Figure 13.3).
• This places appliance back 1/2 inch from framing studs
such that drywall or other material can be brought directly
across non-combustible board up to fi nishing strip.
WARNING! Risk of Fire! 1/2 inch non-combustible board
installed on front face of fi replace MUST remain if using
combustible fi nishing materials.
• A cardboard template is printed on appliance shipping
carton and may be used to help cut drywall or other
fi nishing materials. Simply cut along line and use it as
a template. For Luxor Surround, cut an additional 3 in.
wider than the template.
OPTION E: Corner Mount with Taos Surround
Unit must be placed on 5 3/4 in. tall platform. Platform
should not exceed appliance footprint. See Figure 13.10
Install appliance in corner as tight as minimum clearanc-
es allow. If necessary, shim appliance (up to 1/8 in.) so
that gap between appliance facing and Taos arch is even
throughout as shown in Figure 13.10.
Follow instructions included with Taos Surround for mount-
ing surround to walls.
44
3-in. GAP
SHEETROCK
EDGE
FINISHING STRIP
Heat & Glo • Bravo • 704-902 Rev. J • 10/10
Figure 13.9 Taos Surround on Platform
27-3/4 in.
Figure 13.10 Platform Dimensions
Figure 13.11 Even Gaps All Around.
12-1/8 in.
7-3/4 in.
34-3/8 in.
5-3/4 in.
EVEN GAP