Front Turn Signal And Fog Lamps - Cadillac SRX 2004 Owner's Manual

5. Replace the lower outboard plastic snap-in retainer
in the fender bracket, if needed.
6. Reconnect the electrical harness at the back side of
the headlamp assembly.
7. Push the headlamp assembly straight into the
vehicle engaging the headlamp pin into the
snap-in retainer and adjusting the lamp inboard side
to clear past the front fascia.
8. Reinstall the two fasteners on top of the headlamp
assembly.
9. Reinstall the screw at the lower inboard side of the
headlamp assembly through the hole in the bracket
into the headlamp.
10. Reinstall the fasteners along the top surface of the
front fascia.
To replace the sidemarker and/or parking lamp bulb(s),
do the following:
1. Turn the bulb socket counterclockwise to remove it
from the assembly.
2. Replace the bulb. See Replacement Bulbs on
page 5-58 for the proper bulb number.
3. To reinstall the headlamp assembly, reverse
Steps 5 through 10 of the procedure listed
previously.
5-56

Front Turn Signal and Fog Lamps

To replace the front turn signal and/or fog lamp bulb(s),
do the following:
1. Remove the protection shield located on the
underside of the front of the vehicle by pulling
out the push-pins located on the underside of the
shield. If you are replacing a bulb on the
passenger's side, also use a tool to remove the
fasteners that attach the front fascia extension panel
in the wheelhouse.
2. Remove the two screws located on the inboard side
and bottom of the lamp assembly that attach the
lamp assembly to the front fascia.
3. Remove the lamp assembly from the front fascia by
rotating the lamp assembly rearward to disengage
the outboard hooks of the lamp from the slots
in the front fascia.
4. Disconnect the electrical harness connector from
the back side of the lamp assembly.
5. Remove the six Torx
access cap.
6. If you are replacing the fog lamp bulb, disconnect
the electrical connector from the back of the bulb
socket.
®
screws located on the