Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Blaupunkt Santa Monica C50
Summary of Contents for Blaupunkt Santa Monica C50
- Page 1 Radio / Cassette Santa Monica C50 Operating instructions...
- Page 3 OPERATING ELEMENTS button to unlock release panel Volume control ON button, switches the unit on/ off, mute RDS button, switches the RDS convenience features on/off Selects display for variable text BND button, selects the FM memory bank and the MW and LW wavebands TS, starts the TravelStore function...
-
Page 4: Table Of Contents
CONTENTS Scanning all of the cassette tracks Important information .... 32 (SCAN) ......... 44 Traffic safety ........32 Switching the display mode ... 44 Installation ........32 Resetting the counter ....44 Accessories ........32 Fast forward/rewind ...... 44 Guarantee ........32 Interrupting playback (Pause) .. -
Page 5: Important Information
Before you use your car audio system Amplifiers for the first time, please take the time to read the instruction manual carefully All Blaupunkt amplifiers can be used. and make yourself familiar with the au- CD changers dio equipment. Keep this manual handy The following CD changers can be con- in your car for future reference. -
Page 6: Removable Front Panel
REMOVABLE FRONT PANEL When you remove the operating Removable front panel panel, the car audio system will au- Theft protection system tomatically switch off. To prevent your car audio system from All of the settings will remain being stolen, it has been equipped with stored. -
Page 7: Switching The Car Audio System On/Off
SCHWITCHING ON/OFF Switching the car audio Switching the car audio system on by inserting a cassette tape system on/off If the system is switched off and there The car audio system can be switched is no cassette in the tape deck, on/off in a number of ways. -
Page 8: Volume Control
Blaupunkt specialist dealer. switched back on. This could result If a traffic announcement is received in serious injury to your ears! -
Page 9: Display
VOLUME CONTROL RADIO OPERATION The volume at which phone calls or Radio operation navigation voice output are heard can This car audio system has been be adjusted. equipped with an RDS radio receiver. Press MENU 8. Many FM radio stations now transmit the RDS signal, which contains such : repeatedly until “TEL/ Press... -
Page 10: Selecting Wavebands/Memory Banks
RADIO OPERATION Note: Tuning into radio stations It is necessary to activate/deactivate You can tune into radio stations in a REG in the menu. number of different ways. Switching REG on/off Automatic seek tuning Press MENU 8. Press : repeatedly until “REG” Press The radio will tune into the next availa- appears in the display. -
Page 11: Adjusting Seek Tuning Sensitivity
RADIO OPERATION Adjusting seek tuning sensitivity Storing radio stations automatically (TravelStore) It is possible to adjust the sensitivity of the seek tuning function to tune the ra- You can automatically store the six ra- dio into stations with strong reception dio stations with the strongest reception signals only, or to those with weaker in your current reception area (for FM... -
Page 12: Scanning The Radio Stations Within
RADIO OPERATION Scanning the radio stations Program Type (PTY) within reception range (SCAN) In addition to the radio station name, a number of FM stations transmit informa- You can scan all of the radio stations tion on the type of program they broad- currently within your reception range. -
Page 13: Optimising Radio Reception
RADIO OPERATION Optimising radio reception If you would like to select a different program type, press Interference-related treble cut while the program type is on dis- (HICUT) play to switch to another program The HICUT function improves reception type. when reception begins to deteriorate. If interference occurs, then the treble and Press one of the station preset but- the noise is cut automatically. -
Page 14: Selecting The Display Of Variable Text
RADIO OPERATION TRAFFIC INFORMATION “SHARX OFF” means no bandwidth Traffic information switching, “SHARX ON” means auto- Switching traffic information matic bandwidth switching. priority on/off Press MENU 8 or OK ;. Press TIM @ for longer than 2 sec- Selecting the display of variable onds. -
Page 15: Traffic Information Memory (Tim)
TRAFFIC INFORMATION MEMORY The display will indicate the time and Traffic Information Memory the number of traffic messages record- (TIM) ed. The latest traffic message has the This car radio is able to digitally record lowest number. Messages which are up to four traffic messages with a total older than six hours will be deleted au- length of four minutes. -
Page 16: Tape Deck Operation
TAPE DECK OPERATION Note: Tape deck operation Once the tape reaches the end, it will Starting tape deck operation automatically switch to the other side (autoreverse). If there is no cassette in the tape deck, Skipping music tracks (S-CPS) press To select the next or other following The flip release panel will open. -
Page 17: Scanning All Of The Cassette Tracks (Scan)
TAPE DECK OPERATION Scanning all of the cassette Fast forward/rewind tracks (SCAN) Fast forward Press OK ; for longer than two Press seconds. “FORWARD” will appear in the display. “CAS SCAN” will appear in the display. Scanning will begin with the next track Fast rewind in ascending order. -
Page 18: Blank Skip
TAPE DECK OPERATION Blank skip Traffic information during cassette playback It is possible to automatically skip blank portions of the tape which are longer If you activate the “TRAFFIC” function than ten seconds. Simply activate the (traffic information priority), your car Blank skip function. -
Page 19: Cd Changer Operation
CD CHANGER OPERATION / DIS 7 for longer than two CD changer operation seconds once or repeatedly as re- Note: quired, until the desired information For information on how to handle CDs, appears in the display. how to insert CDs into the changer and Repeating individual tracks or how to operate the changer, please re- fer to the instructions included with the... -
Page 20: Scanning All Of The Tracks On All Of The Cds (Scan)
CD CHANGER OPERATION Note: Stopping PAUSE The CDC A 08 and the IDC A 09 are > during the pause. Press 3 also able to play all of the CDs in the Playback will resume. changer in random order. The other CD changers first play all of the tracks on a Naming CDs CD in random order and then select the... -
Page 21: Clock
CD CHANGER OPERATION CLOCK Deleting a CD name CLOCK You are listening to a CD and Displaying the clock briefly would like to delete its name. To display the time briefly, press Press MENU 8. / DIS 7 briefly. : to select “CDC Press Setting the time NAME”. - Page 22 CLOCK : to alter the minutes. Displaying the time briefly when Press the car radio is switched off Once you have altered the minutes, :. The hours will begin to press To display the time briefly when the car flash. radio is switched off, : to alter the hours.
-
Page 23: Adjusting The Tone And Balance/Fader
TONE AND BALANCE/FADER Adjusting the tone and Switching Loudness on/off balance/fader Loudness boosts the bass and treble when the volume is low to create a more Adjusting the bass natural sound. To adjust the bass, press AUD / LD Press AUD / LD = for approx. two seconds. -
Page 24: Equalizer
EQUALIZER Equalizer Make the settings for the equalizer as described under “What to do”. This car audio system is equipped with a parametric digital equalizer. In this Switching the equalizer on/off case, parametric means that it is possi- To switch the equalizer on, press ble to individually raise or lower one fre- and hold down DEQ <... - Page 25 EQUALIZER...
-
Page 26: External Audio Sources
EQUALIZER EXTERNAL AUDIO SOURCES Adjusting the spectrometer External audio sources The spectrometer in the display uses In addition to the CD changer it is also symbols to temporarily indicate what possible to connect other external au- adjustments are made to the volume, dio sources to the line output. -
Page 27: Tmc For Dynamic Navigation Systems
4 x 40 watts max. tems in route planning. Your car audio power system has been equipped with a TMC output to which Blaupunkt navigation Tuner systems can be connected. To find out which navigation systems you can use Wavebands: with your car audio system, contact your 87.5 - 108 MHz... -
Page 28: Specifications
026 130 04 41 026 130 05 14 800-266 25 28 708-681 71 88 Singapore 006 535 054 47 006 535 053 12 Slovensko 042 175 873 212 042 175 873 229 Blaupunkt-Werke GmbH Bosch Gruppe 02/00 TRO K7/VKD 8 622 402 139...