Smartport ® Wiring Harness; Installing The Smartport Wiring Harness - Hunter ICR Owners And Installation Manual

smartport Wiring Harness .......................................................................
®
To.utilize.the.ICR.remote.control.system,.your.controller.
must.be.equipped.with.a.SmartPort.wiring.harness..This.
wiring.harness.provides.the.communication.port.where.the.
ICR.receiver.is.attached..The.SmartPort.can.be.connected.to.
Hunter.SRC,.Pro-C.and.ICC.controllers..A.SmartPort.wiring.
harness.is.provided.with.your.ICR.remote.system..The.
typical.SmartPort.location.is.approximately.12".below.the.
controller..The.recommended.installation.procedure.for.this.
location.would.be.as.follows:

insTalling THe smartport Wiring Harness ........................................

1.. Install.a.½".female.threaded."Tee".in.the.field.wiring.
conduit.approximately.12".below.the.controller.
NOTE: The harness may be installed outdoors
by bringing the conduit through an exterior
wall, then installing the appropriate fitting.

To Controller
/ " Thread
1
2
Pre-assembled
2.. Feed.the.red,.white,.and.blue.wires.of.the.SmartPort.
through.the.base.of.the."Tee".and.into.the.controller.
wiring.compartment.as.shown.in.the.following.figures..
NOTE: For installations where the receiver
will be installed permanently on an outside
wall, make certain that the SmartPort is the
version with an o-ring seal.
Assembled