Preparing.the.receiver.for.use; Changing.the.receiver.address - Hunter ICR Owners And Installation Manual

2.. Press.the.Mode.button.until.the.
word."Max.Station".appears.
on.the.display..The.maximum.
number.of.stations.will.be..
blinking.at.this.point.
3.. Use.the. .or. .button.
to.increase.or.decrease.the.
maximum.number.of.stations..Then.do.not.touch.any.
of.the.buttons.for.5.seconds.and.the.display.will.stop.
blinking.and.return.back.to.the.active.station.
The.ICR.is.designed.to.operate.with.two.groups.of.Hunter.
controllers:
SRC/Pro-C/ICC Controllers
The.maximum.number.of.stations.from.1.to.48..The.ICR.also.
preparing THe receiver for use ............................................................
As.stated.earlier,.your.ICR.is.designed.to.work.right.out.of.
the.box..If.you.have.decided.to.change.your.Transmitter.
address.as.described.in.the.previous.section,.you.must.allow.
the.Receiver.to."learn".this.new.address..Once.learned,.the.
only.way.to.remove.the.address.from.the.Receiver.memory.
is.to.learn.a.different.address..This.can.be.done.by.following.
the.simple.steps.outlined.below.
provides.the.user.with.the.ability.to.operate.programs..
(A,.B,.C).
ACC/ACC Decoder Controllers
Selecting.the.maximum.station.number.240.allows.the.user.
to.operate.up.to.240.stations.and.18.programs.(programs.
are.displayed.with.a.P.and.program.number.ex:.P5).
NOTE: When the ICR transmitter is set in
the ACC mode (240 stations), the ICR will
only communicate with ACC controllers. To
operate other Hunter controllers (SRC, Pro-C,
and ICC) with your remote, the transmitter
max stations needs to be set to a number from
1 to 48 stations.
Changing the Receiver Address
1.. Hold.down.the.single.button.on.the.face.of.the.
Receiver.while.you.are.plugging.it.into.an.active.
SmartPort .wiring.harness.(one.connected.to.a.
®
powered.controller)..When.this.is.done.the..
Receiver.will.beep.4.times.