Advertisement
Sample of display when properly
4
Figure 1
Configured.
NEC America, Inc.
Document Revision 3
Note: You must use the remote
Program
control to activate the memory
feature. If you do not, the player
will not keep the programming in
1.
If your system has been
previously programmed, press
Stop twice to clear previous
Play
programming.
2.
Using your Track Legend,
choose the messages you wish
Stop
to program.
3.
Turn the CD Player "ON".
4.
Press
Repeat
of the player and insert the
compact disc, writing side up,
into tray. Press
again to close tray.
5.
Press the Program button
once. "PROG" will illuminate
on the display
6.
Press the Repeat button once.
"RPT" will illuminate on the
display.
7.
Using the numbered buttons,
enter the tracks you wish to
program. Pause after each
track until the system prompts
you for the next track.
8.
After all selections have been
made, verify that your display
shows "PROG" and "RPT"
like the display in Figure 1. If
a "1" is showing after "RPT"
press the Repeat button twice.
9.
Press Play.
memory!
on the front
Advertisement
