Hunter 38257 User Manual page 10

5. Attach the Funnel Pump Assembly to
the Power Pack by engaging the three tabs
on the underside of the fan blade. See Figure
17.
Fan Blade
Underside
Power Pack
Funnel Pump
Assembly
Figure 17
6. Place the Power Pack into the Upper
Reservoir so that the three prongs in the
Power Pack go through all three holes in
the Atomizer and into the three prongs in
the base of the Upper Reservoir. Make sure
the Power Pack is securely seated and all
three prongs are in the proper position. See
Figure 18.
If you wish to move your humidifi er to a different
location, follow the instructions as listed below.
DO NOT attempt to carry the humidifi er when
there is water in the Upper Reservoir, Lower
Reservoir, or the Water Tank.
1. Turn the Power Knob to OFF and un-
plug the humidifi er.
2. Remove the Water Tank from the Upper
Reservoir and drain all water.
42992-01 05/23/2006
42992-01/-05.indd 10
Tabs
Relocating the Humidifi er
10
Figure 18
NOTE: The prongs will only fi t into the Upper
Reservoir one way.
7. Follow the directions in the section
REFILLING THE WATER TANK to complete
reassembly.
3. Remove the Upper Reservoir from the
Lower Reservoir and drain all water.
4. If there is water in the Lower Reservoir,
drain all water.
5. Set the Lower Reservoir on the hard,
fl at surface you have chosen.
6. Continue assembly as outlined in the
section REASSEMBLY OF HUMIDIFIER
PARTS.
Power Pack
Atomizer
Holes in the
Atomizer
Upper
Reservoir
©2006 HUNTER FAN CO.
5/23/06, 12:30:15 PM