Table of Contents
Advertisement
4. Installation Instructions
How to Install Your Alarm
Direct Plug Alarm To install:
1. Choose a standard 120V
unswitched outlet to plug the
alarm into.
2. Write the date ten years
from installation on the Replace
by sticker on the CO alarm.
3. If desired, activate the Tamper Resist switch by moving the Tamper
Resist Disable slide away from the Tamper Resist Activation Switch. The
tamper resist feature signals a loud 85dB alarm should the unit become
unplugged or loose from the outlet. (See Tamper Resist Feature details
in the Product Features and Specifications section.)
4. Pull the yellow tab to activate the battery backup.
5. Plug the alarm into the outlet.
Important Labels Provided
Two labels have been provided that have important information on what
to do in case of an alarm. Add the phone number of your emergency
service provider in the space provided. Place one label next to the alarm
after it is mounted, and one label near a fresh air source such as a door
or window.
5. Alarm Characteristics
Carbon Monoxide Alarm Indicator
When the alarm senses a dangerous level of CO, the unit will emit a
loud alarm pattern. The alarm pattern is 4 quick beeps followed by 5
seconds of silence. This cycle repeats as long as a dangerous CO condi-
tions exist. The red Alarm LED will flash the same pattern.
WARNING: When powered by battery backup only; after four
!
minutes, the alarm will sound and flash only once every minute, until
the alarm is reset or the CO is eliminated.
Tamper-Resist
Activate Slide
Tamper-Resist
Activation Switch
Hide quick links:
Advertisement
Table of Contents
