Cooler Installation; Maintenance; Fan Operation; Timer Mode - Champion CP25 Instructions Manual

Install Casters
Note: Casters are located inside unit. These must be removed before starting the unit.
This unit comes equipped with 4 stem casters; 2 locking and 2 non-locking. Before operation turn the unit
on its side and press the stem casters into the corner holes. Install the locking caster on one side of the
unit and the non-locking casters on the opposite side.
Fill With Water
Open the water access door by pressing fi rmly at the top of the door to unlatch
it (see fi g. 1). Fill with a pitcher or water hose. Do Not Overfi ll. Close the
access door, pressing fi rmly at the top of the door until it latches close.
Water Level Indicator
On the front of the unit there is a window to view the level of water in the unit
(see fi g. 2). The red pointer of the indicator will be in the full position with
water near the top of the reservoir. As the water level is decreased in the unit,
the indicator will fall in the window until it reaches the Low indicator.
Power To Unit
Refer to the control panel in fi gure 3 for the following instructions.
When the unit is plugged into an outlet, the power indicator on the
display will be red. Pressing the power button will start the unit in Fan-
High mode. The power indicator in the display will now be blue. The
pump will not start until the pump button is pressed.
Pump / Cooler Operation
To operate this unit as an evaporative cooler, the unit must be fi lled with water and the pump powered on.
Press the pump button to turn on the pump. The water drop indicator on the display will fl ash while the
pump is on. To operate the unit as a fan only, press the pump button again to turn off the pump.

Fan Operation

Pressing the fan button on the control will cycle the fan speed from Low to Mid to High. The fan speed
indicator in the display will be highlighted, showing either 2, 4 or 6 bars depending on the current speed.

Timer Mode

This unit is equipped with a timer. You may set the time interval for the unit to stay on. Pressing the timer
button will set the time interval in 1/2 hour increments up to 12 hours. The display will fl ash while setting
the time and will be solid once it is set. The display will count down the time remaining in 1/2 hour incre-
ments. When the time interval is reached, the unit will turn off.
WARNING: Before doing any maintenance be sure unit is unplugged.
Remove Media Frame
To remove the media frame, fi rst remove the two screws located at the
top of the frame. Press down at the top center of the unit, near the media
frame, until it unsnaps from the media frame. See Fig. 4.
Drain Unit
To drain the unit, remove the media frame and remove the rubber drain stopper from inside the bottom of
the unit by pulling it out of the drain hole. The unit should be drained periodically to keep the water fresh.
We recommend draining the unit once a week. Drain the water from the unit when it will not be used for
an extended period.

Cooler Installation

Operation

Maintenance

2
Fig. 1
Fig. 2
Timer Pump Fan
Fig. 3
Press Here
Screw
Fig. 4
Water
Access
Door
Power
Screw