Cooler Installation; Fan Operation - Champion UltraCOOL CP70 Instruction Manual

Essick air products, inc. portable evaporative cooler instruction manual

Hide thumbs Also See for UltraCOOL CP70:

Specifications (1 page)

Table Of Contents

Table of Contents

Available languages

Install Pedestal and Casters

Unpack the unit and remove the media frame to access the pedestal and 4 cast-

ers. See the maintenance section for instructions on removing media frame.

CAUTION: Do not damage hose connecting pump to media frame. Cut

the cable ties holding pedestal to frame of unit and remove pedestal. Remove

the casters from the underside of the pedestal. To install the pedestal, turn the

unit on it's side. Line up the bosses on the pedestal to the bosses on the base

of the unit (see ﬁ g. 1). Use the four provided screws to attach the pedestal

to the base of unit. Press the stem casters into each corner hole of pedestal,

installing the 2 locking casters on the front and the 2 non-locking on the back

side.

Fill With Water

To ﬁ ll this unit with water, open the water ﬁ ll door and ﬁ ll with a

pitcher or water hose (see ﬁ g. 2). Do Not Overﬁ ll. CAUTION:

Take care when moving unit ﬁ lled with water, spillage may

occur. Unlock casters when moving. Do not tip unit.

Water Level Indicator

On the front of the unit there is an access window to view the

level of the water (see ﬁ g. 2). When the unit is full of water, the

level indicator will be at the top of the window and as the level

of the water is decreased in the unit, the indicator will lower.

Refer to the control panel in ﬁ gure 3 for the following instructions.

Turning On Unit

Once the unit is plugged in, pressing the "Power" button will light up the backlight on the display and start

the unit in Fan-High mode. The pump will not start until the "Pump" button is pressed. The display will

remain backlit for 2 minutes after the last button on the control is pushed.

Pump / Cooler Operation

To operate this unit as an evaporative cooler, the unit must be ﬁ lled with water and the pump powered on.

Press the "Pump" button to turn on the pump. The water drop indicator on the display will ﬂ ash while the

pump is on. To operate the unit as a fan only, press "Pump" to turn off the pump.

Note: The pump will not run if the water level falls below a certain level. When the water level drops

below this level, an audible alarm will sound and the "Low Water" indicator on the display will ﬂ ash on

and off. The audible alarm will stop after 60 seconds or when the "Pump" button is pushed. The indica-

tor will remain ﬂ ashing until the unit is ﬁ lled with water. You will need to restart the pump by pressing

"Pump" after the unit is reﬁ lled with water.

Fan Operation

Pressing the "Speed" button on the control will cycle the fan

speed from High to Mid to Low. The speed setting will be

highlighted in the display.

Oscillate Mode

Pressing the "Oscillate" button will oscillate the vertical vanes

back and forth, distributing the air side to side. The "Oscillate"

indicator on the display will be displayed when on. Press the

button again to turn off.

Timer Mode

This unit is equipped with a timer. You may set the time interval for the unit to stay on. Pressing the

"Timer" button will set the time interval in 1/2 hour increments up to 8 hours. The display will ﬂ ash while

setting the time and will display constantly once it is set. The display will count down the time remaining

in 1/2 hour increments. When the time interval is reached, the unit will turn off.