Attaching The Stand - Blaupunkt 42/333I-GB-5B-F3HBKUP User Manual

Attaching The Stand For 42" TV Set
To complete the stand installation you will require a Phillips screw driver.
The Stand Installation pack comes with two sets
of screws.
fi g 1) Attach the stand neck to the rear of the TV set.
fi g 2) Secure the neck to the TV using the
6 x M (4x16) screws provided.
fi g 3) Attach the stand base to the neck.
fi g 4) Secure the base to the neck using the
5 x ST (4x20) screws provided.
HELPFUL ADVICE FOR FIRST TIME STAND INSTALLATION
When securing the self-tapping screws into the base of the stand (on
fi rst installation) the screws will be naturally tight as they are creating a thread in the plastic of the stand
neck in order to support a TV of this size.
a) Ensure the cross head screw driver tip fi ts correctly into the head of the screw and that it is not too big
or small.
b) Screw in all screws individually and partially before tightening all of the screws individually and partially
until they are fully inserted.
c) If they become very tight try loosening them slightly and then
re-tightening them once again as this will continue the process of
creating the thread for the screws.
For any help concerning set up and use of your TV please call the Customer Helpline: 0871 2000 463
6 x M(4x16)
5 x ST(4x20)
1
6 x
M (4x16)
2
1 1/2
3
4
5 x ST (4x20)
9