Set Up Of Service P.c. Board - Toshiba RAS-B10SKVP-E Service Manual

Before replacing the P .C. board, set up the P .C. board according to the following table.
When repaired P.C. board should be electric discharge of capacitor. (C12, C13, C14)
Caution
APPLICATION MODELS :
RAS-10SAVP-E, RAS-13SAVP-E, RAS-16SAVP-E
RAS-10SAVP-ND, RAS-13SAVP-ND, RAS-16SAVP-ND
JUMPER SET UP :
As shown in the following table, cut jumper lead wire (J800, J801, J802, J806) according to each model.
Corresponding
ORIGINAL
model
Jumper lead wire
J800
Jumper lead wire
J801
Jumper lead wire
J802
Jumper lead wire
J806
LOCATION OF JUMPER LEAD WIRE :

14. SET UP OF SERVICE P.C. BOARD

RAS-
10SAVP-E
Close Close
(Original) (Original)
Close Close
(Original) (Original)
Close Close
(Original) (Original)
Close Close
(Original) (Original)
J800, J801, J802
MCC-5009
C12
RAS- RAS-
13SAVP-E 16SAVP-E
Close Open
(Original) (Cut)
Open Close
(Cut) (Original)
Close Close
(Original) (Original)
Close Close
(Original) (Original)
IC800
L01
C13 C14
– 118 –
RAS- RAS-
10SAVP-ND 13SAVP-ND 16SAVP-ND
Open Close
(Cut) (Original)
Open Close
(Cut) (Original)
Close Open
(Original) (Cut)
Close Close
(Original) (Original)
J806
Capacitor
RAS-
Close
(Original)
Open
(Cut)
Close
(Original)
Close
(Original)