Table of Contents
Advertisement
A. AWARD BIOS: To press "Del" key immediately for a couple of times when powering on
PC and you will get into BIOS set up mode¡ ÷ Select "Advanced" item ¡ ÷ USB Legacy
support¡ ÷ Select "AUTO" ¡ ÷ Save and quit BIOS set up.
B. PHOENIX BIOS¡ G To press "F2" after powering on PC gets into BIOS set up mode¡ ÷
Select "Advanced" item¡ ÷ Legacy USB support¡ ÷ Select "Enable" ¡ ÷
BIOS set up.
C. AMI BIOS¡ G To press "Del" key immediately for a couple of times when powering on PC
and you will get into BIOS set up mode ¡ ÷
controller¡ ÷ all USB port USB KB/Mouse¡ ÷
up.
Note: If the PC BIOS need check keyboard to accomplish boot up process and the PC
might show keyboard error message on the screen, please configure the BIOS setting
again.
When you enter BIOS set up mode, please select the item "Halt on Error" or the other
Error condition setting and select "Halt all errors but Keyboard" or to ignore keyboard
during boot up BIOS process.
Step 8
1. For Windows 98/98SE/DOS user, Please repeat step 3 to 7 for the remainder of the
computers.
2. For Windows ME/XP/NT/2000 user, Please repeat step 3-1 to 6 for the remainder of
the computers.
Step 9
Connect the USB Keyboard to the USB KVM Switch.
Note: For MAC or Sun Microsystems user, please follow up the similar installation
procedure like Windows ME/XP/NT/2000.
Usage
The power on state of 4/8/16 port KVM switch:
When you power on KVM switch, it will ask you the password, the default password value
is eight zero –" 00000000 ". Please key in eight zero and enter the same value at retype
field.
Note: Before you are not familiar with the operation of OSD menu, please don't change the
password – i.e. keep default eight zero (00000000) value. Otherwise, if you have set the
password and unfortunately forget the password, you need send it back to your distributor
for maintaining the password.
Select "Chipset features setup" ¡ ÷
KEYB+MOUSE ¡ ÷
10
Save and quit
Save and quit BIOS set
USB
Advertisement
Table of Contents
