Advertisement
Connecting the AC Power Adapter
To connect the AC adapter to your system: (Reference: Figure 1)
1. Firmly plug the snap-in connector of the DC output cable into AC adapter
output jack.
2. Plug the connector of the DC output cable into the mating DC input
connector on the electronic device.
3. Plug the AC power cord into the AC adapter.
4. Plug the outlet end of the AC power cord into your AC wall outlet.
5. Confirm that the green "Output Present" LED is on and that the
AC adapter is now supplying power to the device.
This connection sequence may be altered without an effect on operation.
You can now use your system with external power supplied by the AC adapter.
Green
LED
Connect output
cable to device
Snap-in output cable to adapter
Specifications
Input voltage
Frequency
Input current
Output voltage
Output current
Weight
Size
Environmental
Operating ambient temperature*
Storage temperature
Operating relative humidity
Ripple & noise
Load regulation
*Operation below 0ºC may result in higher ripple voltage until adapter has warmed.
AC power cord to adapter
AC power cord
to AC source outlet
Figure 1
90 - 264 volts AC
47-63 hertz
1.5 amperes maximum
See adapter label
See adapter label
22 ounces
4.7 x 2.7 x 1.7 inches
-40ºC to +40ºC
-40ºC to +85ºC
5 - 95% non-condensing
2% maximum
+/-5% maximum
Advertisement
