D-Link DWL-2100AP Command Line Interface Reference Manual page 12

get swPower
get SuperG
get wlanstate
get shortpreamble
get wirelessmode
get 11gonly
get antenna
get sta2sta
get eth2sta
get eth2wlan
get macaddress
get config
get countrycode
get hardware
get diap
get aging
get ratecontrol
get supportrate
get MulticastRateControl
get MulticastRateIndex
get MulticastPacketControl
get cpuload
get roguebsstype
get roguesecurity
get roguebandselect
get accountingcfgid
get ifping
get MaxMulticastPacketNumber Display Max Multicast Packet Number
Set Command:
set serviceType
set apmode
set ssid
set ssidsuppress
802.11 b/g Access Point Command Line Interface Manual
Display Software Power Setting
Display SuperG Feature Status of enabled or disabled
Display Wireless LAN state status (enabled or disabled)
Display Short Preamble Usage state: enabled or disabled
Display Wireless LAN Mode (11b or 11g)
Display 11g Only Mode operational state of enabled or disabled
Display Antenna Diversity of 1, 2, or best
Display wireless STAs to wireless STAs connect state
Display ethernet to wireless STAs connect state
Display Eth2Wlan Broadcast packet filter state
Display Mac Address
Display Current AP Configuration Settings
Display Country Code setting
Display Hardware Revisions of WLAN Components
Display DIAP State
Display Aging Interval in seconds
Display supported datarate state
Display supported datarate
Display Multicast Rate Control state
Display Multicast Rate Index
Display Multicast Packet Control state
Get CPU usage
Display ROGUE AP BSS Type
Display ROGUE AP Security Type
Display ROGUE AP Band Select
Display the configuration of Accounting now
Display Ping control status
Function
Set Service Type
Set AP Mode to Normal AP, Point to Point Bridge, Point to Multipoint
Bridge, AP Repeater, or AP Client
Set Service Set ID
Set SSID Suppress Mode enable or disable
get swPower
get SuperG
get wlanstate
get shortpreamble
get wirelessmode
get 11gonly
get antenna
get sta2sta
get eth2sta
get eth2wlan
get macaddress
get config
get countrycode
get hardware
get diap
get aging
get ratecontrol
get supportrate
get MulticastRateControl
get MulticastRateIndex
get MulticastPacketControl
cpuload
get roguebsstype
get roguesecurity
get roguebandselect
get accountingcfgid
get ifping
get MaxMulticastPacketNumber
set serviceType [infrastructure: independent: any]
set apmode [ap:p2p:p2mp:p2pwithoutap: p2mpwithoutap: apr: apc]
set ssid <SSID>
SSID should be less than 33 strings.
set ssidsuppress [disable: enable]
10
Syntax