Fax Share Install Procedure - Mitel TELink 700 FLASH Installation And Operation Manual

FAX SHARE INSTALL PROCEDURE{tc \l2 "INSTALLATION
1. Make sure the power switch on the back of the TELink is in the OFF position.
2. Connect one end of the included modular telephone cable directly to the phone
company box for the installation phone number. The TELink must be connected
before the fax machine. The user may need to adapt one end of the modular cable
to mate to the incoming phone line.
3. Connect the other end of the modular cable to the TELCO jack on the back of the
TELink.
4. Using another modular telephone cable, connect the PHONE jack on the back of the
TELink to the fax machine.
5. Set the HI/LO switch on the back of the TELink to the proper position for the
telephone system (LO=8 Ω, HI=1K Ω).
6. Connect the TELink's AUDIO OUTPUT jack to the telephone system's MOH input
using the included RCA cable. The user may need to adapt the phone system end of
this cable to match the MOH input connection on the phone system.
7. Plug the included 12VDC power supply into a normal 110VAC wall outlet. Connect
the other end to the 12VDC jack on the back of the TELink.
8. Set the fax machine to answer on the fewest rings possible (but a minimum of two
rings).
Mitel TELink 700 FLASH
PROCEDURE C}
9 06/2009