Voice Line And/Or Night Answer Install Procedure - Mitel TELink 700 FLASH Installation And Operation Manual

VOICE LINE AND/OR NIGHT ANSWER INSTALL
PROCEDURE{tc \l2 "INSTALLATION PROCEDURE A}
1. Make sure the power switch on the back of the TELink is in the OFF position.
2. Connect one end of the included modular telephone cable directly to the phone
company box for the installation phone number. It is important that this cable is
attached to a direct line, prior to any other telephone equipment. The user may need
to adapt one end of the modular cable to mate to the incoming phone line.
If the TELink is equipped with the Night Answer option, the installation line must be
the first line answered by the telephone system. If you are not sure which line this is,
check with your local phone company.
3. Connect the other end of the modular cable to the TELCO jack on the back of the
TELink.
4. Using another modular telephone cable, connect the PHONE jack on the back of the
TELink to the installation phone line's original destination (KSU, PBX, telephone,
etc).
5. Set the HI/LO switch on the back of the TELink to the proper position for the
telephone system (LO=8 Ω, HI=1K Ω).
6. Connect the TELink's AUDIO OUTPUT jack to the telephone system's MOH input
using the included RCA cable. The user may need to adapt the phone system end of
this cable to match the MOH input connection on the phone system.
7. Plug the included 12VDC power supply into a normal 110VAC wall outlet. Connect
the other end to the 12VDC jack on the back of the TELink.
8. Turn the power switch ON. Turn to page 9 for further instructions.
Mitel TELink 700 FLASH 6 06/2009