Table of Contents
Advertisement
1. Memory module cover
9. Install the battery pack - refer to
Chapter 6, Power and Power-Up Modes, if required.
10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start -> Control Panel -> System and Security ->
System icon.
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
User's Manual
Figure 3-8 Seating the memory module cover
(Satellite/Satellite Pro/PORTÉGÉ T210/T210D)
Figure 3-9 Seating the memory module cover
(Satellite/Satellite Pro/PORTÉGÉ T230/T230D)
Turning off the power
Hardware, Utilities and Options
2. Screw
Replacing the battery pack
section in Chapter 1, Getting Started if
section in Chapter 6, Power and Power-Up
2
1
2
1
section in
3-23
Advertisement
Table of Contents
