Ci Information; General Information; Troubleshooting; Causes Of Interference - Hyundai H-LED32V18T2 Instruction Manual

General information

CI information

(only in DTV mode): This function enables you to watch some encrypted services (pay
services). Please insert a CI card into the PCMCIA slot according to the arrow on the CI card.
• The function can only be available when CI card is present.
• It is possible for you to change CI (Common Interface) menu screen and service by
consulting your dealer.
• Please do not insert or pull out the CI card when power on. During initialization of the CI card,
please don't operate the TV.
• Do not insert or pull out the CI card frequently so as to avoid any damages of the TV and the
CI card.

Troubleshooting

Below is a table describing simple measures that can help you eliminate most problems likely
to emerge when this unit is in use. If below measures do not help, turn to a service center or to the
nearest dealer.
Symptom
No picture, no The power cord is not plugged in.
sound, and no Contrast, brightness, color and
indicator light volume are all in the minimum value
or TV is in mute mode.
Picture and Contrast and color are set improperly.
sound with Color system is set improperly.
abnormity Sound system is set improperly.
The picture in The PC settings may be improper.
VGA mode is
abnormal
Picture is spotted Signal source is low-grade or the
or with snow signal is in a lower quality.
Blue background No video signal or the signal cord is
improperly/not connected.
No sound No audio signal or the signal cord is
improperly/not connected.
The RC does not Batteries are improperly installed or
work exhausted.

Causes of interference

Incorporated in your TV receiver are the most up-to-date devices to eliminate interference.
Local radiation however, can create disturbances, which visibly affect your picture. Proper
14
Cause Solution
Plug the power cord in.
Alter the value of contrast,
brightness, color and volume.
Set the value of Contrast and color
properly.
Set the sound system properly.
Check and set the resolution
parameters of your PC.
Use the qualified signal cord.
Connect the signal cord properly.
Connect the audio signal cord
properly.
Set the sound system properly.
Make sure the positive and the
negative polarities are correct.
Reattach the battery lid.
Replace the batteries.