Table of Contents
Advertisement
Password Check
System
Setup
Init Display First
This feature allows you to select the first initiation of the monitor display from which card when you
install a PCI card and a PCI Express VGA card on the motherboard.
PCI Slot
Onboard VGA
PEG
Frame Buffer Size
16MB
32MB
64MB
128MB
Disabled
Onboard GPU
Note: Please set to "Always Enable" when use dual view function.
Enable If No Ext PEG
Always Enable
GA-K8N51GMF Motherboard
The system can not boot and can not access to Setup page will be
denied if the correct password is not entered at the prompt.
The system will boot, but access to Setup will be denied if the correct
password is not entered at the prompt. (Default value)
Set Init Display First to PCI VGA card.
Set Init Display First to onboard VGA.
Set Init Display First to PCI Express VGA card.(Default value)
Set On-chip frame buffer size to 16MB.
Set On-chip frame buffer size to 32MB.
Set On-chip frame buffer size to 64MB.(Default value)
Set On-chip frame buffer size to 128MB.
Disable this function.
Onboard GPU will be disabled if there is a graphics card on the PCI
Express slot. (Default value)
Onboard GPU will always be enabled whether there is a graphics card
on the PCI Express slot or not.
- 34 -
Advertisement
Table of Contents
